Industrial lubricants quality control

Most of the lubrication of machinery and equipment to implement regular oil change system. It not only ignores the specific changes in the quality of oil during use, but also does not take into account the actual working conditions, it may even result in the use of oil can be used to replace the waste phenomenon, or continue to use the metamorphic fuel (due to the unexpired) And cause poor lubrication, resulting in equipment failure. The quality of lubricating oil changes after long-distance transportation at the factory and the storage of oil depots at all levels affected by the external natural environment or human error. Therefore, it is necessary to conduct laboratory analysis on the installed oil and carry out oil change by quality.

First of all, the newly purchased oil storage should be carried out before the quality test to prevent unqualified oil storage. Second, the equipment for oil should be based on the actual situation of various types of mechanical equipment regularly test, Suzhou Industrial Lubricants, which on the large fuel consumption of hydraulic transmission equipment and large, fine, dilute equipment should be tested one by one. According to the test results, if the quality is still eligible to extend the use of time, until it is not only when the table is replaced. The test of equipment oil should be 9 conventional physical and chemical indicators (viscosity, flash point, water, pH, ash residual carbon, bulk density, mechanical impurities, corrosive and water-soluble acid and alkali).

     Promote equipment fixed qualitative test oil system can not only save a lot of lubricants, but also make the equipment to ensure the quality of oil. To conserve energy, extend equipment life, reduce lubrication accidents, reduce production costs, are very useful.